Winter Park runs its own electric utility, and much of its historic housing was wired before grounding was standard. Both shape how a surge protector goes in here.
A quality Type 2 device at the panel is the low end. Layered protection — panel plus point-of-use at AC, well pump, and electronics — is the upper end.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Historic district homes from the 1920s to 40s often have cloth wiring, knob-and-tube remnants and no grounding at all. A suppressor diverts a surge to ground, so on these houses grounding and bonding get corrected before the device is worth installing.
Plenty of homes here still run 60 or 100 amp services. If the panel is due for replacement anyway, we will say so, because a new or replaced service needs a surge protector under the code Florida uses and it makes sense to do both at once.
Newer infill and rebuilds along the lakes carry landscape lighting, dock circuits and high-end fixtures. That is where layered protection, panel plus point-of-use, earns its upper-range price.
The City of Winter Park owns and operates its own electric utility, so service coordination goes through the city rather than OUC or Duke. Permits go to Winter Park Building & Permitting Services.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
Mike is in Winter Park most Tuesdays. You will have a name and a text before anyone is at your door.
"Grant wired our new kitchen project. We have used him two other times and plan on using him with our next project."
"…In Phaze sent 3 people for the job, which they completed in 1 day, even vacuuming up afterwards."
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
No. A strip clamps small transients at one outlet. A service-entrance surge comes in on the feeders and reaches everything at once.
They wear out absorbing hits. Good devices show status with an indicator; we tell you what to look for and check it on any future visit.
Nothing stops a direct strike to the structure. This handles the far more common case — nearby strikes and utility switching surges.
A panel device helps. For the compressor and control board specifically, a dedicated device at the condenser is the better answer.
It is the part that matters most, and it is the part most often wrong. We verify and correct grounding before installing anything.
Some carriers give credit. Worth a call to your agent with the model number we install.
Free estimate. If you do not need the work, we will tell you — which is why people in Winter Park call us back years later.