SERVICES16
SERVICE AREAS15
Electrical panel replacement in Winter Springs, FL
Winter Springs panels are mostly 1980s–90s originals now carrying two renovations and a pool, under a tree canopy that takes the power out in storms other neighborhoods sleep through.
Interior swaps sit at the low end. Exterior meter-main combination panels cost more because the meter can, mast and riser come with them and the utility has to release the meter.
Four things that are only true in Winter Springs.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Pool loads added over decades
Pumps and heaters added one at a time to a panel sized for a different house is the usual story here. A load calculation shows whether you need a new panel, more amps, or just corrected circuits.
Aluminum wiring in the earlier builds
Some Tuskawilla corridor homes from the earlier builds have aluminum branch wiring. When we replace the panel we look at those terminations too, rather than landing old aluminum on new breakers and walking away.
Plan the generator with the panel
Generator interest here is genuine. If one is on your list, deciding it now means the new panel is laid out for the transfer equipment instead of reworked later.
Duke, city or county
Duke Energy serves all of Winter Springs and releases the meter. We file with the City of Winter Springs Building Division, or Seminole County outside the limits, and meet the inspector.
Real numbers before you call.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
How the day goes
Victor and Keylin cover east Seminole. You will have a name and a text before anyone is at your door.
Real reviews, word for word.
"Grant wired our new kitchen project. We have used him two other times and plan on using him with our next project."
"…In Phaze sent 3 people for the job, which they completed in 1 day, even vacuuming up afterwards."
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
Straight answers.
What is the difference between an interior and exterior panel replacement?
An interior load center lives in a garage, hallway or closet and is usually the simpler job. An exterior meter-main combination panel sits on the outside wall with the meter, so it involves the meter can, the mast and the utility — more parts, more coordination, more cost.
Do I really need 200 amps?
Not always. If you are not adding load, a 100-amp service in good condition can be fine. We do a load calculation first — if the answer is no, we say no.
How long is the power off?
Typically six to eight hours in one day. We schedule it in the morning so you are back on by dinner.
Who pulls the permit?
We do. Our office files it, schedules the inspection, and meets the inspector. You handle nothing.
Will you patch the wall?
Yes. If we open drywall we close it. That is part of the job, not a change order.
Is a Federal Pacific panel really dangerous?
Stab-Lok breakers have a documented failure-to-trip rate. We will show you what is in your panel and let you decide with real information.
Earned one job
at a time.
Panel replacement in Winter Springs, done right.
Free estimate. If you do not need the work, we will tell you — which is why people in Winter Springs call us back years later.