A lot of Apopka's 1970s–80s homes are still on their original panels, many of them replacement candidates, and much of that older housing is on a well.
Interior swaps sit at the low end. Exterior meter-main combination panels cost more because the meter can, mast and riser come with them and the utility has to release the meter.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Errol Estates, Sweetwater West and the older parts of town have plenty of original panels still in service. We open yours at the estimate and tell you plainly whether it needs replacing or just attention.
A new or replaced service needs whole-home surge protection under the code Florida uses, and we include it. With a well pump, it is the difference between a storm and a week without water.
Agricultural and nursery properties here have three-phase service, irrigation pumps and outbuildings wired by whoever was available at the time. If your panel feeds those, we look at them before quoting rather than pricing from the main panel alone.
Duke Energy serves most of Apopka and releases the meter. We file with the City of Apopka Building Department or Orange County outside the limits. Newer homes along 429 and 441 are usually a capacity question, not a failing panel.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
William and Josh cover northwest Orange. You will have a name and a text before anyone is at your door.
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
"Our old panel dated back to 1984 and was overdue for replacement. We worked directly with Keylin, who was outstanding from start to finish."
"…tried to over charge for work that was not even necessary. In Phaze offered an alternative option at a fraction of the cost."
An interior load center lives in a garage, hallway or closet and is usually the simpler job. An exterior meter-main combination panel sits on the outside wall with the meter, so it involves the meter can, the mast and the utility — more parts, more coordination, more cost.
Not always. If you are not adding load, a 100-amp service in good condition can be fine. We do a load calculation first — if the answer is no, we say no.
Typically six to eight hours in one day. We schedule it in the morning so you are back on by dinner.
We do. Our office files it, schedules the inspection, and meets the inspector. You handle nothing.
Yes. If we open drywall we close it. That is part of the job, not a change order.
Stab-Lok breakers have a documented failure-to-trip rate. We will show you what is in your panel and let you decide with real information.
Free estimate. If you do not need the work, we will tell you — which is why people in Apopka call us back years later.