In Longwood a fan job can be a simple swap or a reason to look at the panel. If the new fan needs a new circuit, the 1970s panels common here come into it.
Installation only; you supply the fan. $277 for the first fan on an existing fan-rated box, about $180 for each additional fan on the same visit. A light-only box has to be replaced with a fan-rated one first; remotes and wall controls are extra.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Most fan swaps stay on the existing circuit. If yours needs a new circuit and the house has a Federal Pacific or Zinsco panel, as many in Sweetwater Oaks and Wekiva do, we tell you plainly before adding to it.
Some of the oldest homes in Seminole County are here, and the ceiling wiring can be as old as the house. We check the wire and the box before a fan gets hung on either.
Bigger lots mean screened patios, pool areas and sheds that want a fan. Those spots need a damp- or wet-rated fan, and a shed may need a switch and box where none exists, quoted at the estimate.
An older fan that hums or wobbles is often sitting on a box that was never rated for it. We replace it with a fan-rated brace box when needed, then balance the new fan at every speed.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
Grant and Jason cover Seminole County. You will have a name and a text before anyone is at your door.
"Grant wired our new kitchen project. We have used him two other times and plan on using him with our next project."
"…In Phaze sent 3 people for the job, which they completed in 1 day, even vacuuming up afterwards."
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
No. Our price is the installation; you buy the fan you like and have it on site. The fan-rated box, remote or wall control are parts we supply and are priced on the estimate.
Usually, but the box has to be rated for a fan. Most light boxes are not, and a fan on the wrong box works loose over time. We swap it for a fan-rated brace box first.
We cut in a fan-rated box and run power from a nearby switch or circuit, then patch what we open. That is quoted at the estimate because access varies.
Yes, with two wires to a dual switch, a wall control or a remote. If there is only one switched wire, a remote is usually the cleanest answer.
Yes. We size the downrod and use a sloped-ceiling adapter where needed. Very tall ceilings may need a taller ladder or lift, which we price up front.
Yes. Use a damp- or wet-rated fan outdoors; indoor fans rust and fail quickly in Florida humidity.
Free estimate. If you do not need the work, we will tell you — which is why people in Longwood call us back years later.