SERVICES16
SERVICE AREAS15
Pool, Spa and Hot Tub Electrical in Winter Park, FL
Winter Park's older homes were wired for a couple of window units, not a 240-volt spa. Before a hot tub goes on the patio, we confirm the service and the panel can actually take it.
That range is a typical hot tub or swim spa hookup: a dedicated 240-volt circuit and a GFCI disconnect. Short runs from a panel with room are the low end; long or underground runs and panels without space are the top. Pool equipment circuit repairs are diagnosed at our service rate and priced before we fix them.
Four things that are only true in Winter Park.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
60 and 100 amp services
Many historic-district homes still run 60 or 100 amp services. A spa that needs a 50 or 60 amp circuit may not fit on one without a service change, and a load calculation tells you that before the tub is delivered.
The city is the utility
Winter Park runs its own electric utility, so if the service has to be upgraded for a tub, the meter work is coordinated with the city, not OUC or Duke. That adds a step to the schedule, and we plan around it.
Lakefront rebuilds
Newer rebuilds along the lakes tend to have the capacity, and the work is about placement: the GFCI disconnect within sight of the tub, at least 5 feet from the water, somewhere that still looks tidy on a finished patio.
Permits through the city
Hot tub circuits and pool equipment work are permitted through City of Winter Park Building & Permitting Services. Our office files it and meets the inspector, so you do not need to be home for the inspection.
Real numbers before you call.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
How a hot tub hookup goes
Mike is in Winter Park most Tuesdays. You will have a name and a text before anyone is at your door.
Real reviews, word for word.
"Grant wired our new kitchen project. We have used him two other times and plan on using him with our next project."
"…In Phaze sent 3 people for the job, which they completed in 1 day, even vacuuming up afterwards."
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
Straight answers.
What size circuit does a hot tub need?
Most 240-volt hot tubs need a 40, 50 or 60 amp circuit; swim spas can need more. The tub's spec sheet decides it, and we size the wire and breaker to match.
Does a hot tub need a disconnect?
Yes. Code requires a disconnect within sight of the tub and at least 5 feet away from the water's edge, and the circuit must be GFCI protected. A GFCI disconnect handles both.
Can I plug in a 120-volt plug-and-play spa?
If it is rated for it, it needs its own GFCI-protected outlet on a dedicated circuit, not a shared patio outlet or an extension cord. Many people later convert to 240 volts so it heats faster.
What is pool bonding?
Connecting the pool steel, rails, pump, ladders and nearby metal together so they sit at the same voltage. It is what keeps the water from shocking you. Missing or broken bonding shows up on inspections and should be fixed.
I felt a tingle in the pool. What should I do?
Get everyone out, turn off the pool equipment breakers, and call. Do not swim until it is tested.
Do you install pool pumps or heaters?
We do the electrical side: circuits, disconnects, timers and bonding. The pool company sets the equipment itself.
Earned one job
at a time.
Pool, spa & hot tub in Winter Park, done right.
Free estimate. If you do not need the work, we will tell you — which is why people in Winter Park call us back years later.