Sanford's lakefront and riverfront homes put dock lighting near the top of the list. In the historic district, the porch light and outdoor outlet are often on some of the oldest wiring in the region.
A starter set with a transformer, a timer and a handful of fixtures sits at the low end. A full yard with several zones, long underground runs and dock or pool-deck lighting is the top. Single fixtures and floods are priced per light.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Dock lighting needs GFCI protection, wet-rated fixtures and the clearances code sets near water. If the lights and the lift share an old circuit, we look at whether that still makes sense. Lights go low and aimed down, onto the boards and steps.
Knob-and-tube still turns up in the historic district. Swapping a porch light means looking at the box and wire behind it. If the insulation crumbles when we touch it, a fixture swap becomes a short new run, and we tell you before we start.
An LED landscape system draws very little, so a 60-amp post-war service usually has room for it. The weak spot is the outdoor outlet. With no grounding and no GFCI, it needs to be replaced before a transformer plugs into it.
Sanford is on FPL, so a dark streetlight is FPL's to fix. A new outdoor circuit is filed with the City of Sanford Building Division inside city limits or Seminole County outside. We handle the filing.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
Grant handles Sanford and north Seminole. You will have a name and a text before anyone is at your door.
"Grant wired our new kitchen project. We have used him two other times and plan on using him with our next project."
"…In Phaze sent 3 people for the job, which they completed in 1 day, even vacuuming up afterwards."
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
Most path and accent lighting is low-voltage: a transformer plugs into a GFCI outlet and safer 12-volt wire runs to the fixtures. Security floods and soffit lights are usually line-voltage. Many yards use both, and we wire each the right way.
Low-voltage cable is buried shallow along beds. Line-voltage runs go in conduit at the depth code requires. Either way nothing is left lying on the grass.
Yes. A photocell turns them on at dusk, a timer turns them off when you choose, and an astronomic or smart timer follows sunset through the year.
Fixtures, connectors and boxes must be rated for wet locations, and every outdoor outlet needs GFCI protection. Most landscape lights that fail early used indoor-grade connectors.
Often. Dead runs are usually a corroded splice, a failed transformer or a tripped GFCI. We find it at our service rate and tell you whether a repair or a new system makes more sense.
Yes. Lighting near water has extra code rules on GFCI protection and distance, and we follow them. Pool and spa circuits themselves are covered on our pool and hot tub page.
Free estimate. If you do not need the work, we will tell you — which is why people in Sanford call us back years later.