In St. Cloud's new subdivisions, outdoor lighting starts from a bare yard. On rural property it starts with distance, because the barn, the well and the gate can be a long way from the house.
A starter set with a transformer, a timer and a handful of fixtures sits at the low end. A full yard with several zones, long underground runs and dock or pool-deck lighting is the top. Single fixtures and floods are priced per light.
If you could swap the city name out of this page and it would still be accurate, it should not exist. Here is what actually changes here.
Newer homes south and east of downtown have outdoor GFCI outlets, so a low-voltage set can often plug right in. If your community has an association that reviews exterior changes, check before fixtures go on the house.
On rural property a pole light or barn flood is often more useful than path lights. It needs a line-voltage feed in conduit, and over these distances the wire is sized so the light at the end gets full voltage.
Manufactured homes have their own service and bonding requirements. Outdoor lighting on one is fed and grounded to match, and we check how the home is supplied first.
The city is served through OUC and Duke Energy serves parts of the county, so confirm yours if a streetlight is out. New outdoor circuits go to the City of St. Cloud Building Department or Osceola County.
Same ranges we publish everywhere, because the work does not cost more just because of the zip code. You get an exact number at the free estimate.
Keylin covers south Osceola. You will have a name and a text before anyone is at your door.
"After getting the run around from other electricians I came across In Phase. Wish I found them first."
"Unlike some of their competitors, they don't try to up-sell products that aren't strictly necessary."
"Our old panel dated back to 1984 and was overdue for replacement. We worked directly with Keylin, who was outstanding from start to finish."
"…tried to over charge for work that was not even necessary. In Phaze offered an alternative option at a fraction of the cost."
Most path and accent lighting is low-voltage: a transformer plugs into a GFCI outlet and safer 12-volt wire runs to the fixtures. Security floods and soffit lights are usually line-voltage. Many yards use both, and we wire each the right way.
Low-voltage cable is buried shallow along beds. Line-voltage runs go in conduit at the depth code requires. Either way nothing is left lying on the grass.
Yes. A photocell turns them on at dusk, a timer turns them off when you choose, and an astronomic or smart timer follows sunset through the year.
Fixtures, connectors and boxes must be rated for wet locations, and every outdoor outlet needs GFCI protection. Most landscape lights that fail early used indoor-grade connectors.
Often. Dead runs are usually a corroded splice, a failed transformer or a tripped GFCI. We find it at our service rate and tell you whether a repair or a new system makes more sense.
Yes. Lighting near water has extra code rules on GFCI protection and distance, and we follow them. Pool and spa circuits themselves are covered on our pool and hot tub page.
Free estimate. If you do not need the work, we will tell you — which is why people in St. Cloud call us back years later.